The ORIGINAL Aztek Fan Club

AZTEK GARAGE (Peer Support) => UPHOLSTERY/MODS-INTERIOR => Topic started by: Mechavenatrix on January 15, 2020, 05:40:59 AM



Title: Rendezvous Interior in Aztek
Post by: Mechavenatrix on January 15, 2020, 05:40:59 AM
As the title says, does anyone know which pieces from a Rendezvous would fit in an aztek?

I know the seats are a direct swap, but I'm looking at the dash pad (the upper part of the dash that faces upwards under the windshield) if it fits with the aztek or the cluster. I have a guy that'll sell me these pieces very cheap, but before I try the labor I thought I'd ask here if they're compatible.


Title: Re: Rendezvous Interior in Aztek
Post by: Pontiac6KSTEAWD on January 15, 2020, 05:51:28 PM
I would not say the front seats are a direct swap, they are wider, but since there is no center console, they should work fine.

Cluster is a no from what I have been told on another Aztek Forum (Facebook).

Are you talking about the dash Vent/Hud Bezel? That should swap over. But colors will not match.

Rear seats are a NO

Door Panels are a NO

Labor? The Bezel comes out in like 7 minutes, the hardest part is unplugging the headlight sensor. The rest are just pop clips that come out really easy. Just replaced the Bezel on my Rendezvous for one with a HUD, swapped super easy. The hard part was un-installing, and installing the HUD unit. that was a SOB!


Title: Re: Rendezvous Interior in Aztek
Post by: Daisy on January 16, 2020, 03:24:10 PM
I just had to steal the back off a rendezvous pilot seat (06/07?) and while all the upholstery fit fine, I overlooked the fact that the Aztek armrest mounting bracket is a weld-on piece that is NOT included with the rendezvous seat back.

That said, if you're a person who uses an armrest and not planning to swap out the center console from one, you won't necessarily have one from a Rendezvous seat, or be able to easily add one in.