Welcome to the site! Take a minute to register and join us. It's FREE! (and fun)
The ORIGINAL Aztek Fan Club Welcome, Guest. Please login or register.
Did you miss your activation email?
Always stay logged in

Login with username, password and session length
Home Gallery Help Login Register
Pages: [1]   Go Down
  Print  
Author Topic: Probably a repeat but. Rear Bearing Assembly AWD removal  (Read 2475 times)
0 Members and 1 Guest are viewing this topic.
nimrodtoo
Member
*
Offline Offline

Posts: 3


« on: December 26, 2010, 07:14:32 PM »

Newbie here. Bought daughter a 2002 Aztek AWD. Previous owner gave me two front bearings. Replaced them both no big issues. The story is good, I'll post that some other time. Now AWD and Anti-lock lights are on. Traced to right rear (passenger). OK, same part, no biggie. Take tire off, take brakes off, take rotor off, take 3 mounting bolts off. The wheel bearing will not come loose. I have pounded the crap out of it, penetrating oil, etc. etc.
 Am I missing something? This was supposed to be an hour project. Help anyone?

Nimrod
Logged
Dumpy
100 Club Members
****
Offline Offline

Posts: 104



« Reply #1 on: January 29, 2011, 10:13:52 AM »

Hi Nimrod

Did you try a search? I think I remember reading that a puller may be needed...
Logged

Yellow 2002 1SB FWD
bearpause99
Guest
« Reply #2 on: January 29, 2011, 06:16:07 PM »

Easy... Just as you said.... No puller... detatch caliper and three bolts... Took my mechanic about half an hour start to finish.
Logged
CDN AZCRACK
Member
*
Offline Offline

Posts: 6


« Reply #3 on: September 23, 2011, 08:01:07 PM »

Hi, newbie here as well. I just replaced all 4 hubs on an 02 tek I picked up for $700. A puller did no good, I used a chisel between the old hub and the backing plate. The old hub was siezed tight. This worked great on all 4 hubs. Hope this helps.
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Powered by SMF 1.1.20 | SMF © 2013, Simple Machines
Theme Underground Yellow